How to Install NR200 Engine into the Boat? | Stirlingkit

How to Install NR200 Engine into the Boat?

Nr200 engine is one of the most popular scale 4 stroke RC engine model. some people ask me if i can make a tutorial for those who owns a boat. it's also suitable for the 70-12cm long boat/ ship. so that's it.

Step 1: Remove the flywheel of the engine.

Step 2: Install the clutch kit.

Choose the appropriate transmission mode, gear drive or pulley drive.

Step 3: Check whether the clutch combination is tight and the operation is smooth.

Step 4: Make a simple U-shaped aluminum seat or bracket for placing the fixed engine.

Step 5: Self-made simple steering gear linkage lever throttle device. The remote control servo can control the engine throttle.

Step 6: Place the engine as a whole in the RC model (take a boat as an example), and connect the clutch output shaft to the oar or the gearbox on the car.

Step 7: Connect the circuit, oil circuit and water circuit of the engine. The exhaust port is extended to the outside of the model cabin.

Step 8: Connect the power supply, turn on the power, start the engine, test the power output, and drive on the road after the running-in is completed.

Several cases:

NR200 Startup and Exhaust Note by Irond4n.